carpet cement::Is the simplest and least expensive solution, and tackless installation is ideal because the carpet can be removed easily if the bedroom is no longer needed carpet cement

carpet cement::Is the simplest and least expensive solution, and tackless installation is ideal because the carpet can be removed easily if the bedroom is no longer needed.
However, redoing a basement or garage probably means installing the carpet over concrete.
Using tackless carpet cement to fasten down the tackless strips and the padding will make the job easier.
If you are installing carpet directly over concrete, check for moisture problems and make sure they are corrected.
Excess moisture will prevent tackless carpet cement from adhering properly and can ruin your new carpet.
Sweep the floor so that it is clean of debris.
Lay the tackless strips around the perimeter of the room so that they are end to end and then cut the strips to fit into corners and around door jambs.
The ends should be cut straight across and butted flatly together where they meet.
Tackless cement is specially formulated for bonding carpet tack strips to almost any flooring surface.
Adhesives like this will have a bond time of between two and twentyfour hours.
The high strength of the cement permits immediate power stretching, but it is highly powerful and flammable, so use it carefully.
Lay the strips adhesive side up and allow the strips and floor to dry separately.
Return the strips to their original position on the floor after a twentyfour hour curing time.
Using a hammer and a small wooden block, work along the length of each strip, tapping firmly to fasten each strip to the floor.
This tapping will activate the adhesive and form a removable bond between the floor and the strips.
Cut the padding in strips long enough to fit the length of the room.
Make sure the padding is long enough to cover the tackless strips on all of the walls.
The padding should not overlap; padding pieces should be butted up against each other to form a clean seam.
The padding is now ready to be cemented to the floor.
Using too much adhesive will permanently bond the padding to the floor and prevent later removal.
Once the padding is glued down, use a utility knife to trim the excess padding that is covering the tackless strips, and cover each seam with duct tape.
This floor treatment will look great for five to ten years, depending on usage, and is easily replaced or removed if necessary.
carpet cement::Now i have been loking into mostly set up lately and
through the help of an instructor and some friends at another website,
i have figured out why my weight never shifted correctly to the rear
heal carpet cement